The stamp was a success! After conducting some tests, I've achieved a beautiful stamp. I purchased a sheet of rubber stamp material, measuring 11.50" x 8.50" and 0.09 inches deep from Amazon, for less than $9.00 (https://amzn.to/48t7PoE) (aff link). The process was straightforward. I designed my artwork using design software, then imported it into Lightburn where I adjusted the ramp settings. This step is crucial as it adds stability to the design, preventing it from collapsing when pressed into the stamp material.
Before engraving and cutting, I mirrored the design. The engraving process was a bit messy due to the rubber creating a powdery residue, but my Aeon Mira 9 laser handled it smoothly without any hiccups. To complete my stamp and provide durability during use, I affixed a 1-inch piece of birchwood that I had cut with my laser